You are here:
Contribution of regional-scale fire events to ozone and PM2.5 air quality estimated by photochemical modeling approaches
Citation:
Baker, K., M. Woody, G. Tonnesen, Bill Hutzell, H. Pye, M. Beaver, G. Pouliot, AND Tom Pierce. Contribution of regional-scale fire events to ozone and PM2.5 air quality estimated by photochemical modeling approaches. ATMOSPHERIC ENVIRONMENT. Elsevier Science Ltd, New York, NY, 140:539–554, (2016).
Impact/Purpose:
The National Exposure Research Laboratory (NERL) Computational Exposure Division (CED) develops and evaluates data, decision-support tools, and models to be applied to media-specific or receptor-specific problem areas. CED uses modeling-based approaches to characterize exposures, evaluate fate and transport, and support environmental diagnostics/forensics with input from multiple data sources. It also develops media- and receptor-specific models, process models, and decision support tools for use both within and outside of EPA.
Description:
Two specific fires from 2011 are tracked for local to regional scale contribution to ozone (O3) and fine particulate matter (PM2.5) using a freely available regulatory modeling system that includes the BlueSky wildland fire emissions tool, Spare Matrix Operator Kernel Emissions (SMOKE) model, Weather and Research Forecasting (WRF) meteorological model, and Community Multiscale Air Quality (CMAQ) photochemical grid model. The modeling system was applied to track the contribution from a wildfire (Wallow) and prescribed fire (Flint Hills) using both source sensitivity and source apportionment approaches. The model estimated fire contribution to primary and secondary pollutants are comparable using source sensitivity (brute-force zero out) and source apportionment (Integrated Source Apportionment Method) approaches. Model estimated O3 enhancement relative to CO is similar to values reported in literature indicating the modeling system captures the range of O3 inhibition possible near fires and O3 production both near the fire and downwind. O3 and peroxyacetyl nitrate (PAN) are formed in the fire plume and transported downwind along with highly reactive VOC species such as formaldehyde and acetaldehyde that are both emitted by the fire and rapidly produced in the fire plume by VOC oxidation reactions. PAN and aldehydes contribute to continued downwind O3 production. The transport and thermal decomposition of PAN to nitrogen oxides (NOX) enables O3 production in areas limited by NOX availability and the photolysis of aldehydes to produce free radicals (HOX) causes increased O3 production in NOX rich areas. The modeling system tends to overestimate hourly surface O3 at routine rural monitors in close proximity to the fires when the model predicts elevated fire impacts on O3 and Hazard Mapping System (HMS) data indicates possible fire impact. A sensitivity simulation in which solar radiation and photolysis rates were more aggressively attenuated by aerosol in the plume reduced model O3 but does not eliminate this bias. A comparison of model predicted daily average speciated PM2.5 at surface rural routine network sites when the model predicts fire impacts from either of these fires shows a tendency toward overestimation of PM2.5 organic aerosol in close proximity to these fires. The standard version of the CMAQ treats primarily emitted organic aerosol as non-volatile. An alternative approach for treating organic aerosol as semi-volatile resulted in lower PM2.5 organic aerosol from these fires but does not eliminate the bias. Future work should focus on modeling specific fire events that are well characterized in terms of size, emissions, and have extensive measurements taken near the fire and downwind to better constrain model representation of important physical and chemical processes (e.g. aerosol photolysis attenuation and organic aerosol treatment) related to wild and prescribed fires.
