You are here:
Sample Processing Approach for Detection of Ricin in Surface Samples
Shah, S., S. Kane, A. Erler, AND T. Alfaro. Sample Processing Approach for Detection of Ricin in Surface Samples . JOURNAL OF IMMUNOLOGICAL METHODS. Elsevier Science Ltd, New York, NY, , 9, (2017).
Ricin biotoxin is one of the high-priority biological threat agents. Several ricin bioterrorism incidents have occurred in the U.S. During the EPA response to such incidents, environmental samples need to be collected for ricin analysis. During the 2013 ricin contamination incident in Tupelo, MS, inconclusive results for the post-decontamination phase samples were obtained due to interference with the sample analysis method used. During the subsequent ricin incidents in 2014-2015, the EPA Office of Emergency Management (OEM) faced difficulties with getting the post-decontamination samples analyzed by desired and appropriate methods. While providing the technical support, the EPA ORD’s National Homeland Security Research Center (NHSRC) determined that inclusion of a sample processing method is needed to clean up the post-bleach-decontamination samples before the analysis. Therefore, the NHSRC undertook a research and development (R&D) project to trouble-shoot the analytical method interference problem and develop a sample processing method. This R&D effort identified the need for a proper QC check and proper dilution of a critical reagent to mitigate the problem of analytical method interference. Also, an ultrafiltration device-based approach was developed to clean up environmental samples. This approach not only helps clean up the ricin samples, but also, helps concentrate the ricin in the samples, up to 20-fold, and thereby, enables detection of ricin at lower concentrations. This, in turn, helps with minimizing the false negative results during the sample analysis. This manuscript includes the research work done in this project. Since this sample processing method is not specific for any analytical method, it could be used as a front-end to any ricin sample analytical method. This method is developed for use by the EPA’s Environmental Response Laboratory Network (ERLN) managed by the EPA OEM and the Water Laboratory Alliance (WLA) network managed by the EPA Office of Water (OW). It can also be useful to other Federal Agencies’ laboratory networks for a national level need.
URLs/Downloads:Free access through PubMed Central Exit
SAMPLE PROCESSING APPROACH FOR DETECTION OF RICIN IN SURFACE SAMPLES Exit