WARNING! DATA USE RESTRICTIONS

Read Carefully Before Using

The EPA does all it can to ensure that the identity of survey participants cannot be disclosed. All direct identifiers, as well as any characteristics that might lead to identifications, are omitted from the data. Any intentional identification or disclosure of a person or establishment violates the assurances of confidentiality given to the providers of the information. Therefore, users will (1) use the data in this study for statistical reporting and analysis only; (2) make no use of the identity of any person or establishment discovered inadvertently and will advise the HEDS Administrator of any such discovery; (3) will not link this data with individually identifiable data from other EPA or non-EPA data.

By using the data you signify your agreement to comply with the above-stated statutorily based requirements.

Citation:

Description:

This data set includes analytical results for measurements of metals in 49 field control samples (spikes). Measurements were made for up to 11 metals in samples of water, blood, and urine. Field controls were used to assess recovery of target analytes from a sample media during storage, shipment, processing, and analysis. Field controls were prepared by fortifying a suitable background-free matrix identical or similar to the sample being collected. Controls were prepared in the labs and shipped to the field site. They were then returned along with the samples. Field controls were used for some sample media, with the controls deployed for a small percentage of the study participants. In several cases where there may not have been suitable media or means of fortification, field controls were not collected. Keywords: metals; quality assurance; field control; spike.

The National Human Exposure Assessment Survey (NHEXAS) is a federal interagency research effort coordinated by the Environmental Protection Agency (EPA), Office of Research and Development (ORD). Phase I consists of demonstration/scoping studies using probability-based sampling designs. The Region 5 study was conducted in EPA's Region 5 (Ohio, Michigan, Illinois, Indiana, Wisconsin, and Minnesota), and included personal exposure, residential concentration, and biomarker measurements of metals and VOCs. The study was conducted by the Research Triangle Institute (RTI) and the Environmental and Occupational Health Sciences Institute (EOHSI). The scope and design of the study are detailed in the following article: E. Pellizzari et al., Population-Based Exposure Measurements in EPA Region 5: A Phase I Field Study in Support of the National Human Exposure Assessment Survey. Journal of Exposure Analysis and Environmental Epidemiology, Vol. 5, No. 3, 1995, pp. 327-358.

NOTE: The U.S. Environmental Protection Agency (EPA), through its Office of Research and Development (ORD), partially funded and collaborated in the research described here. Mention of trade names or commercial products does not constitute endorsement or recommendation by EPA for use.

URLs/Downloads:

Record Details:

Related Organizations:

Quality Assurance:

These data are the result of a probability-based sampling design specific to the population under study. Thus the data may or may not be representative of subsets of this study's population or of other populations. The study was designed to test certain hypotheses, and this may limit its applicability for other purposes. When using these data it is important to consider the percentage of non-responses or non-detects in the data as an indicator of its usefulness for other purposes. No liability is accepted by the U.S. EPA for any errors or omissions in the results included in the data sets, associated information, and/or documentation.

Based on the output format selected by the user and the software into which the data set is imported, users may notice that measurements and sampling weights are zero-padded to the right of non-zero decimal digits. These zeroes are purely a function of the formatting process and the software's acceptance of that format and should not be construed to represent significant digits in the value. Measurement values are provided with four significant digits; sampling weights are provided with three decimal digits.