You are here:
HYDROCARBON VAPOR DIFFUSION IN INTACT CORE SLEEVES
Citation:
Ostendorf, D. W., Z. E. Moyer, Y. Xie, AND R. V. Rajan. HYDROCARBON VAPOR DIFFUSION IN INTACT CORE SLEEVES. GROUNDWATER MONITORING AND REMEDIATION 13(1):139-150, (1993).
Impact/Purpose:
Information.
Description:
The diffusion of 2,2,4-trimethylpentane (TMP) and 2,2,5-trimethylhexane (TMH) vapors put of residually contaminated sandy soil from the U.S. Environmental Protection Agency (EPA) field research site at Traverse City, Michigan, was measured and modeled. The headspace of an intact core sleeve sample was swept with nitrogen gas to simulate the diffusive release of hydrocarbon vapors from residual aviation gasoline in and immediately above the capillary fringe to a soil-venting air flow in the unsaturated zone. The resulting steady-state profile was modeled using existing diffusivity and air porosity estimates in a balance of diffusive flux and a first order source term. The source strength, which was calibrated with the observed flux of 2,2,4-TMP leaving the sleeve, varied with the residual gasoline remaining in the core, but was independent of the headspace sweep flow rate. This finding suggested that lower soil-venting air flow rates were in principle as effective as higher air flow rates in venting LNAPL vapors from contaminated soils. The saturated vapor concentration ratio of 2,2,4-TMP to 2,2,5-TMH decreased from 6.6 to 3.5 over the duration of the experiments in an expression of distillation effects. The vertical profile model was tested against sample port data in four separate experiments for both species, yielding mean errors ranging from 0 to—24 percent in magnitude.
URLs/Downloads:
HYDROCARBON VAPOR DIFFUSION IN INTACT CORE SLEEVES
URL.PDF (PDF, NA pp, 22 KB, about PDF)