Record Display for the EPA National Library Catalog
RECORD NUMBER: 39 OF 3656
|OLS Field Name||OLS Field Data|
|Main Title||Air emissions from reinforced plastics composite manufacturing process Lasco panel products : final report. Vol. 1. Report text, appendix A.1 /|
|Author||Meadows, F. ; Scheffel, D. F.|
|CORP Author||Pacific Environmental Services.|
|Publisher||U.S. Environmental Protection Agency, Office of Air Quality Planning and Standards,|
|Report Number||EPA-454/R-99-024a; EPA-68-D-70069|
|Additional Subjects||Air pollution ; Reinforced plastics ; Emissions ; Quality assurance ; Quality control ; Manufacturing ; Composites ; Clean Air Act ; Testing ; Sampling ; Lamination processes ; Sytrene ; Volatile organic compounds ; Maximum Achievable Control Technology(MACT) ; Total hydrocarbons ; Florence(Kentucky)|
|Collation||498 pages : illustrations|
The United State Environmental Protection Agency (EPA) Emission Standards Division (ESD) requested that the EPA's Emissions Monitoring and Analysis Division (EMAD), Emission Measurement Center (EMC) provide testing support in the investigation of the reinforced plastics composite manufacturing source category to properly set the Maximum Achievable Control Technology (MACT) standards as required by the Clean Air Act Amendments of 1990. The reinforced plastics composite manufacturing process located at LASCO Panel Products in Florence, Kentucky was selected by the ESD as the host facility for this emissions testing program. The sampling program was designed to support the following ESD objectives: (1) Identify and quantify the hazardous air pollutants (HAPs) emitted by reinforced plastic manufacturing, (2) Identify the sources of HAPs and the total HAPs mass emission rates from the wet application area and the oven area, (3) Evaluate three ventilation scenarios, (4) Depending on the effectiveness of the industry proposed 'closed' system, develop a performance-based emission limitation achieved by the use of a wet area enclosed table system, (5) Assess the existing emission factors for volatile organic compound emissions from a continuous lamination process for the purposes of updating the information in AP-42 and determining cost effectiveness for MACT options involving emissions abatement, and (6) Determine the effect of various process parameters such as line speed, laminate thickness, HAP content of raw material and the addition of a gel coat layer on the emission factor. Sampling was performed during 13 process operating conditions. Measurements were made of the total hydrocarbons (THC), styrene, cumene, and methyl methacrylate (MMA), and the air flow rate at all enclosure exhausts. A secondary objective of the sampling program was to obtain the emissions of HAPs from the oven stacks. This volume (Volume I) is comprised of 464 pages and consists of the report text and Appendix A.1 (Manual Methods Raw Field Data).
EPA project officer: Solomon Ricks. "Author(s): Franklin Meadows, Daniel F. Scheffel"--Technical rep. data. Prepared by Pacific Environmental Services, Inc. for U.S. Environmental Protection Agency, Office of Air Quality Planning and Standards, Emissions, Monitoring and Analysis Division. "August 1999." "EPA-454/R-99-024a"--Cover. Microfiche.
v. 1. Report text, appendix A.1 -- v. 2. Appendix A.2 -- v. 3 Appendix B, C, D, and E.