Record Display for the EPA National Library Catalog

RECORD NUMBER: 2 OF 7

Main Title Air emissions from reinforced plastics composite manufacturing process Lasco panel products : final report. Vol. 1. Report text, appendix A.1 /
Author Meadows, F. ; Scheffel, D. F.
Other Authors
Author Title of a Work
Meadows, Franklin.
Scheffel, Daniel F.
Ricks, Solomon.
CORP Author Pacific Environmental Services.
Publisher U.S. Environmental Protection Agency, Office of Air Quality Planning and Standards,
Year Published 1999
Report Number EPA-454/R-99-024a; EPA-68-D-70069
Stock Number PB2002-100915
Additional Subjects Air pollution ; Reinforced plastics ; Emissions ; Quality assurance ; Quality control ; Manufacturing ; Composites ; Clean Air Act ; Testing ; Sampling ; Lamination processes ; Sytrene ; Volatile organic compounds ; Maximum Achievable Control Technology(MACT) ; Total hydrocarbons ; Florence(Kentucky)
Holdings
Library Call Number Additional Info Location Last
Modified
Checkout
Status
NTIS  PB2002-100915 Some EPA libraries have a fiche copy filed under the call number shown. 07/26/2022
Collation 498 pages : illustrations
Abstract
The United State Environmental Protection Agency (EPA) Emission Standards Division (ESD) requested that the EPA's Emissions Monitoring and Analysis Division (EMAD), Emission Measurement Center (EMC) provide testing support in the investigation of the reinforced plastics composite manufacturing source category to properly set the Maximum Achievable Control Technology (MACT) standards as required by the Clean Air Act Amendments of 1990. The reinforced plastics composite manufacturing process located at LASCO Panel Products in Florence, Kentucky was selected by the ESD as the host facility for this emissions testing program. The sampling program was designed to support the following ESD objectives: (1) Identify and quantify the hazardous air pollutants (HAPs) emitted by reinforced plastic manufacturing, (2) Identify the sources of HAPs and the total HAPs mass emission rates from the wet application area and the oven area, (3) Evaluate three ventilation scenarios, (4) Depending on the effectiveness of the industry proposed 'closed' system, develop a performance-based emission limitation achieved by the use of a wet area enclosed table system, (5) Assess the existing emission factors for volatile organic compound emissions from a continuous lamination process for the purposes of updating the information in AP-42 and determining cost effectiveness for MACT options involving emissions abatement, and (6) Determine the effect of various process parameters such as line speed, laminate thickness, HAP content of raw material and the addition of a gel coat layer on the emission factor. Sampling was performed during 13 process operating conditions. Measurements were made of the total hydrocarbons (THC), styrene, cumene, and methyl methacrylate (MMA), and the air flow rate at all enclosure exhausts. A secondary objective of the sampling program was to obtain the emissions of HAPs from the oven stacks. This volume (Volume I) is comprised of 464 pages and consists of the report text and Appendix A.1 (Manual Methods Raw Field Data).
Notes
EPA project officer: Solomon Ricks. "Author(s): Franklin Meadows, Daniel F. Scheffel"--Technical rep. data. Prepared by Pacific Environmental Services, Inc. for U.S. Environmental Protection Agency, Office of Air Quality Planning and Standards, Emissions, Monitoring and Analysis Division. "August 1999." "EPA-454/R-99-024a"--Cover. Microfiche.
Contents Notes
v. 1. Report text, appendix A.1 -- v. 2. Appendix A.2 -- v. 3 Appendix B, C, D, and E.