Record Display for the EPA National Library Catalog

RECORD NUMBER: 4 OF 18

OLS Field Name OLS Field Data
Main Title Buffer Additives for Lime/Limestone Slurry Scrubbing: Sulfite Oxidation with Enhanced Oxygen Absorption Catalyzed by Transition Metals.
Author Uhlrich, R. K. ; Rochelle, G. T. ;
CORP Author Texas Univ. at Austin. Dept. of Chemical Engineering.;Industrial Environmental Research Lab., Research Triangle Park, NC.
Year Published 1984
Report Number EPA-R-809386; EPA-600/7-84-058;
Stock Number PB84-189950
Additional Subjects Air pollution control ; Buffers(Chemistry) ; Additives ; Sulfites ; Calcium oxides ; Scrubbers ; Oxidation ; Absorption ; Catalysis ; EDTA ; Transition metals ; Reaction kinetics ; Mass transfer ; pH ; Flue gases ; Limestone scrubbing ; Flue gas desulfurization
Holdings
Library Call Number Additional Info Location Last
Modified
Checkout
Status
NTIS  PB84-189950 Most EPA libraries have a fiche copy filed under the call number shown. Check with individual libraries about paper copy. 06/23/1988
Collation 189p
Abstract
The report gives results of a study of sulfite oxidation, involving the measurement of the rate of enhanced oxygen absorption across an unbroken interface into solution containing sulfite (2-100 mM) and catalyst (0.01-100 mM) at pH 4-6 and 50 C. Fe, Mn, Co, Cu and Cr ions were potent catalysts under these conditions; Ni was inactive. At 10 mM, these catalysts gave pseudo-first order (in oxygen) rate constants of 8.6, 43, 4.7, 95 and 11 sec, respectively. Dry catalyst added in its upper valence state (ferric, cupric, chromic) produced high initial rates that fell in 1 to 6 hours to steady state, while catalyst added in its lower state (ferrous, manganous, cobaltous) showed no high rates and reached steady state in less than 1 minute. Ferric and ferrous eventually resulted in the same rate. Fe was a much stronger catalyst than Mn or Co, but its rate was limited by Fe solubility of about 0.01 mM at pH 5, resulting in an enhancement factor of 2.4 at all higher concentrations. Thiosulfate (0.05-1 mM) had a stronger inhibiting effect and efficiency on Mn than on Fe. EDTA was an effective inhibitor for Fe at equal or greater concentrations. Rates for Fe and Co increased with pH from 4 to 5, while those for Mn were unchanged. Strong positive Mn-Fe synergisms were found to cause absorption rates of up to five times those expected.