Office of Research and Development Publications

NHEXAS PHASE I REGION 5 STUDY--STANDARD OPERATING PROCEDURE FOR COLLECTION, STORAGE, AND SHIPMENT OF STANDING TAP WATER SAMPLES FOR METALS AND ARSENIC BY EPA METHOD 200.8 (RTI/ACS-AP-209-001)

Notice:

WARNING! DATA USE RESTRICTIONS

Read Carefully Before Using

The EPA does all it can to ensure that the identity of survey participants cannot be disclosed. All direct identifiers, as well as any characteristics that might lead to identifications, are omitted from the data. Any intentional identification or disclosure of a person or establishment violates the assurances of confidentiality given to the providers of the information. Therefore, users will (1) use the data in this study for statistical reporting and analysis only; (2) make no use of the identity of any person or establishment discovered inadvertently and will advise the HEDS Administrator of any such discovery; (3) will not link this data with individually identifiable data from other EPA or non-EPA data.

By using the data you signify your agreement to comply with the above-stated statutorily based requirements.

Citation:

Region 5 Study Consortium. NHEXAS PHASE I REGION 5 STUDY--STANDARD OPERATING PROCEDURE FOR COLLECTION, STORAGE, AND SHIPMENT OF STANDING TAP WATER SAMPLES FOR METALS AND ARSENIC BY EPA METHOD 200.8 (RTI/ACS-AP-209-001). U.S. Environmental Protection Agency, Washington, D.C., 1995.

Description:

This protocol describes the procedures for the collection, storage, and shipping of standing tap water samples to be analyzed by EPA Method 200.8 (version 4.4). Standing tap water is the water that has been stored undisturbed inside of home plumbing for at least four hours prior to collection. The procedure specified that standing water samples be collected at the kitchen tap by a resident of the participant household. The samples were collected for total recoverable elements. The NHEXAS primary target analytes are lead and arsenic. The secondary analytes are cadmium and chromium. This protocol describes the sample containers, sample collection, preservation, storage, shipping, and custody procedures. Keywords: tap water; metals.

The National Human Exposure Assessment Survey (NHEXAS) is a federal interagency research effort coordinated by the Environmental Protection Agency (EPA), Office of Research and Development (ORD). Phase I consists of demonstration/scoping studies using probability-based sampling designs. The Region 5 study was conducted in EPA's Region 5 (Ohio, Michigan, Illinois, Indiana, Wisconsin, and Minnesota), and included personal exposure, residential concentration, and biomarker measurements of metals and VOCs. The study was conducted by the Research Triangle Institute (RTI) and the Environmental and Occupational Health Sciences Institute (EOHSI). The scope and design of the study are detailed in the following article: E. Pellizzari et al., Population-Based Exposure Measurements in EPA Region 5: A Phase I Field Study in Support of the National Human Exposure Assessment Survey. Journal of Exposure Analysis and Environmental Epidemiology, Vol. 5, No. 3, 1995, pp. 327-358.

NOTE: The U.S. Environmental Protection Agency (EPA), through its Office of Research and Development (ORD), partially funded and collaborated in the research described here. Mention of trade names or commercial products does not constitute endorsement or recommendation by EPA for use. This SOP is part of the Quality Systems Implementation Plan (QSIP) that was reviewed by the EPA and approved for use in this demonstration/scoping study. This SOP was used in the study and is provided for documentation purposes. It does not reflect EPA methods and should not be construed as such. The methods were generated by the consortium to be used for the NHEXAS pilot study.

URLs/Downloads:

HEDS STUDIES

STUDY DIRECTORY

COMPLETE DOCUMENT  (PDF, NA pp,  229  KB,  about PDF)

Record Details:

Record Type:DOCUMENT( REPORT )
Product Published Date:05/17/1995
Record Last Revised:12/22/2005
Record ID: 16860