You are here:
EPA SITE DEMONSTRATION OF THE BIOTROL SOIL WASHING PROCESS
Citation:
Stinson*, M K., H. S. Skovronek, AND W. D. Ellis. EPA SITE DEMONSTRATION OF THE BIOTROL SOIL WASHING PROCESS. JOURNAL OF THE AIR & WASTE MANAGEMENT ASSOCIATION. Air & Waste Management Association, Pittsburgh, PA, 42(1):96-103, (1992).
Impact/Purpose:
information
Description:
A pilot-scale soil washing process, patented by BioTrol, Inc., was demonstrate on soil contaminated by wood treating waste, primarily pentachlorophenol (PCP) and creosote-derived polynuclear aromatic hydrocarbons (PAHs). Although soil washing was the main object of this demonstration, the treatment train that was evaluated included two other BioTrol technologies for treatment of waste streams from the soil washer. The three technologies were: ● The BioTrol Soil Washer (BSW)—a volume reduction process, which uses water to separate contaminated soil fractions from the bulk of the soil. ● The BioTrol Aqueous Treatment System (BATS)—a biological water treatment process. ● The Slurry Bioreactor (SBR)—a BioTrol biological slurry treatment process conducted in an EIMCO BIOLIFTtm reactor. The sandy soil at the site, consisting of less than 10 percent of fines, was well suited for treatment by soil washing. The soil washer was evaluated in two tests on soil samples containing 130 ppm and 680 ppm of PCP, respectively. The BSW successfully separated the feed soil (dry weight basis) into 83 percent of washed soil, 10 percent of woody residues, and 7 percent of fines. The washed soil retained about 10 percent of the feed soil contamination while 90 percent of the feed soil contamination was contained within the woody residues, fines, and process water. The soil washer achieved up to 89 percent removal of PCP and 88 percent of total PAHs, based on the difference between their levels in the as-is (wet) feed soil and the washed soil. PCP concentrations of 14 ppm and 87 ppm in the washed soil were achieved from PCP concentrations of 130 ppm and 680 ppm in the feed soil. Concentrations of total PAHs were reduced from 247 ppm to 42 ppm and 404 ppm to 48 ppm, respectively, in the two tests. The BATS degraded up to 94 percent of PCP in the process water from soil washing. PAH removal could not be determined due to low influent concentrations. The SBR achieved over 90 percent removals of PCP and 70 to 90 percent removals of PAHs from the slurry of contaminated fines from soil washing. However, steady state operation was not achieved during the single test and the results were variable. Cost of a commercial-scale soil washing, assuming use of all three technologies, was estimated to be $168 per ton of soil treated. Incineration of woody material accounts for 76 percent of the cost.
