Jump to main content or area navigation.

Contact Us

Extramural Research

Project Research Results
Grantee Research Project Results

Grantee Research Project Results

Final Report: Reagentless Field-Usable Fixed-Site and Portable Analyzer for Trihalomethane (THM) Concentrations in Drinking Water

EPA Contract Number: EPD09028
Title: Reagentless Field-Usable Fixed-Site and Portable Analyzer for Trihalomethane (THM) Concentrations in Drinking Water
Investigators: Findlay, Mel
Small Business: KWJ Engineering, Inc.
EPA Contact: Manager, SBIR Program
Phase: I
Project Period: February 1, 2009 through July 31, 2009
Project Amount: $70,000
RFA: Small Business Innovation Research (SBIR) - Phase I (2009)
Research Category: SBIR - Water and Wastewater , Small Business Innovation Research (SBIR)

Description:

U.S. Environmental Protection Agency (EPA) regulations require corrective action for drinking water distribution systems that exceed the maximum contaminant level (MCL) of 80 µg/L for total trihalomethanes (TTHMs). Real-time or even periodic monitoring of drinking water, however, currently is not economically feasible. Available methods use gas chromatography and are expensive and plagued with long delay times between sample collection and results. A sensor allowing rapid response, real-time measurement of TTHM concentrations in water systems would be ideal for identifying contaminant “hot spots” and allowing system operators to implement immediate mitigation.  

The purpose of this research is to develop and demonstrate the feasibility of a sensitive, halogen-selective sensor and simple analytical method that can measure TTHM at concentrations below the EPA regulated level. The selectivity has been demonstrated in prior work. This research will focus on the sensor design and fabrication processes to improve accuracy, reduce power requirements, and reduce the cost of analysis.

In the 1990s, a team including the Principal Investigator for this project developed a sensor for screening groundwater contaminated by chlorinated solvents. A sensor was fabricated in a process very similar to the heated metal oxide sensor (HMOS). Unlike HMOS, this sensor was extremely selective to halogenated organic vapors while showing virtually no response to any other commonly encountered contaminant. While useful for field screening, the sensor did not have the accuracy or sensitivity needed to meet the drinking water requirements. 

During Phase I of this SBIR project, KWJ designed and fabricated a thick film sensor chip with the rare-earth coating on it, to compare to the original “bead-type” sensor fabricated previously. Sensitivity, repeatability, and selectivity were evaluated as functions of sensor geometry and ceramic coating composition. Next, several perm-selective sampler designs were built and tested, and sensitivity to each of the four THM compounds in water was demonstrated.
 

Summary/Accomplishments (Outputs/Outcomes):

During Phase I, KWJ demonstrated extreme sensitivity and selectivity of the sensor. Testing showed a minimum detection limit of less than 10 ppbv for CHCl3, and less than 25 ppbv for bromoform, which is the least sensitive of the THM compounds. KWJ also demonstrated sensor response to each of the four THMs dissolved in water, with concentrations as low as 25 µg/L CHCl3 detected. Several options for rapid speciation were evaluated, with the target of <60 seconds analysis time.

Conclusions:

1.  KWJ's approach has shown the necessary sensitivity and response time for measuring low ppb levels of THM compounds rapidly.

2.  Lifetime and calibration intervals for the sensor will be determined in Phase II, but have shown the potential to meet or exceed the application requirements.

3.  The sampler for dissolved THMs performed well with respect to sensitivity.
 
In general, the sensors developed during Phase I of this research have proven their feasibility for use in field usable fixed-site and portable analyzers for THM in drinking water. Phase II work is planned and will be needed to optimize the performance of the sensor, sampler, and evaluate a pre-concentrator to potentially be used in a commercial product. The Phase I research is very promising, and has certainly validated KWJ's approach to this human health and safety issue.
 
 
COMMERCIALIZATION:
 
During Phase I, KWJ solidified both its supply and delivery channels for commercial products that will result from this research. A number of commercial facilities for the production of KWJ’s proprietary MEMS sensors were consulted, and several potential partners in the development and manufacture of these sensors were identified. These confidential relationships will be further examined in Phase II.
KWJ also identified new markets through its existing customers and distributors, both for the sensors and the instruments that will result from these efforts. In addition to its use for analyzing hazardous substances in drinking water, KWJ's approach can be used to detect volatile organic compounds (VOCs) and chloramines in swimming pools and spas. Furthermore, KWJ’s proprietary microfabricated MEMS sensor can be adapted to detect a wide variety of other analytes with significantly lower power requirements and cost over existing technologies. KWJ’s principals, Dr. Joe Stetter and Mr. Ken Johnson, have a combined 100 years of successful experience in the development and commercialization of advanced technologies for gas detection. KWJ is committed to using all of its available resources for the successful commercialization of the results of this research in Phase II and Phase III.

Supplemental Keywords:

small business, SBIR, EPA, drinking water, drinking water distribution system, maximum contaminant level, MCL, drinking water monitoring, trihalomethane, THM, total trihalomethane, TTHM, real-time measurement, contaminant hotspot, mitigation, sensor, portable analyzer, chlorinated organic vapors, lanthanum oxide, lanthanum fluoride, microelectrome system, MEMS, chemical sensor, thermal detection, battery power

Progress and Final Reports:
Original Abstract

SBIR Phase II:

Reagentless Field-Usable Fixed-Site and Portable Analyzer for Trihalomethane (THM) Concentrations in Drinking Water  | Final Report

Top of Page

The perspectives, information and conclusions conveyed in research project abstracts, progress reports, final reports, journal abstracts and journal publications convey the viewpoints of the principal investigator and may not represent the views and policies of ORD and EPA. Conclusions drawn by the principal investigators have not been reviewed by the Agency.

Jump to main content.